Intel SR1695GPRX, Service Manual

Page: 59 / 174

Intel
®
Server System SR1695GPRX Service Guide 39
6. Reinstall and reconnect any parts you removed or disconnected to reach the
processor sockets.
7. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
Installing and Removing a Hot-swap Hard Drive
You can install up to two fixed SATA drives in the Intel
®
Server System SR1695GPRX.
See “Server System References” for a link to a list of supported hardware.
Caution: If you install less than four drives or devices, the empty drive bays must be occupied by
carriers with drive blanks to maintain proper system cooling.
To avoid possible damage to your server system, use only the drive carriers that came
with your system.
Installing a SAS or SATA Hot-swap Hard Disk Drive
Note: The server system does not support all hard drives. See “Server System References” for a
link to a list of supported hardware.
1. Open the latch at the front of the hard drive carrier (see letter “A”).
2. Pull out on the black lever and slide the carrier from the server system (see letter
“B”).
Figure 22. Pulling out the back lever
3. Remove the hard drive from its wrapper and place it on an antistatic surface.
4. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
AF003302
A
B