Intel Server Board SE7501BR2
Installation and Integration Guide
Installing the Chassis Feet (Pedestal Mode)
Installing the Chassis Feet (Pedestal Mode)
1.
If you are installing this server into a rack system, s
these steps and go to “Installing into a Rack (Rack
Mode)” below.
1.
If you are installing this server into a rack system, s
these steps and go to “Installing into a Rack (Rack
Mode)” below.
kip
kip
2.
Move the chassis to the edge of your workbench.
2.
Move the chassis to the edge of your workbench.
3.
Use four screws to attach each foot to the chassis. The
holes in the feet line up with only one set of holes in
the chassis. On the front foot, the middle hole should
face toward the front of the chassis. Hole locations for
the front foot are marked “F” and “1, 2”. On the back
foot, the middle hole should face toward the back of
the chassis. Location holes for the rear foot are
marked “F”.
3.
Use four screws to attach each foot to the chassis. The
holes in the feet line up with only one set of holes in
the chassis. On the front foot, the middle hole should
face toward the front of the chassis. Hole locations for
the front foot are marked “F” and “1, 2”. On the back
foot, the middle hole should face toward the back of
the chassis. Location holes for the rear foot are
marked “F”.
Installing into a Rack (Rack Mode)
Installing into a Rack (Rack Mode)
The Intel Server Chassis SC5200 is designed to be
compatible with the EIA-310-d rack standard. Be sure to
select a rack cabinet enclosure that is EIA-310-d
compliant. For additional compatibility and rack cabinet
selection information, see:
The Intel Server Chassis SC5200 is designed to be
compatible with the EIA-310-d rack standard. Be sure to
select a rack cabinet enclosure that is EIA-310-d
compliant. For additional compatibility and rack cabinet
selection information, see:
http://support.intel.com/support/motherboards/server/ch
http://support.intel.com/support/motherboards/server/ch
assis/sc5200
1.
Fully extend the rails.
2.
Remove the smallest and innermost rail.
3.
Position the rail.
4.
Insert and tighten four screws.
5.
Install the rest of the rail in your rack.
✏
NOTE
Your rack may vary from the illustration. Refer to your
rack documentation for information specific to your rack.
6.
Hold the chassis so the rails on the chassis engage the rails in
your rack. You will need someone to help you at this point.
7.
Disengage the locking tab on each rail and slide the server
into the rack.
22
