Server Utilities
3 Server
Utilities
Using the BIOS Setup Utility
The BIOS Setup program is accessed by pressing the <F2> key after the Power-On Self-Test
(POST) memory test begins and before the operating system boot begins. For the latest BIOS Setup
menu options, go to the Intel World Wide Web site:
http://support.Intel.com/support/motherboards/server/SE7221BA1-E/
Setting the BIOS Configuration Jumper Block
CAUTION
Always turn off the power and unplug the power cord from the computer
before changing the jumper. Moving the jumper with the power on may
result in unreliable computer operation.
The three-pin BIOS jumper block enables all board configurations to be done in BIOS Setup. Table 3
shows the jumper settings for the Setup program modes.
Table 3. Jumper Settings for the BIOS Setup Program Modes
Jumper Setting
Mode
Description
3
1
Normal
(default) (1-2)
The BIOS uses the current configuration and passwords for booting.
3
1
Configure (2-3)
After the Power-On Self-Test (POST) runs, the BIOS displays the
Maintenance Menu. Use this menu to clear passwords.
3
1
Recovery
(None)
The BIOS recovers data from a recovery diskette in the event of a
failed BIOS update.
Clearing Passwords
This procedure assumes that the board is installed in the computer and the configuration jumper
block is set to normal mode.
1. Observe the precautions in "
" at the beginning of this document.
2. Turn off all peripheral devices connected to the computer. Turn off the computer. Disconnect
the computer’s power cord from the AC power source (wall outlet or power adapter).
3. Remove the computer cover.
4. Find the configuration jumper block.
Intel® Entry Server Board SE7221BA1-E User Guide
21