Intel SBCEFCSW, Installation Manual

Page: 51 / 62

37
2. In the
Default file password
field, type the new password.
3. In the
Re-enter password to confirm
field, type the same password again.
4. Click
OK to save your changes.
✏
NOTE
If you lose the password for the account, contact your Intel Support Representative.
Setting user preferences
Use the Preferences window to perform the following tasks:
• Change the location of the working directory that you will use to save files.
• Change the location of the browser used to view the online help.
• Choose the fabric discovery interval. Rates are 30, 45, or 60 seconds. The fabric discovery interval
indicates how often the SAN Utility polls the fabric.
• Enable or disable the default view file auto save and load feature. See “Using the SAN Utility” on page 34
for more information about the default fabric view file.
• Select the default port view when opening the SAN Utility Faceplate window (referred to as the Faceplate
window). See the Intel
®
Blade Server Switch Module SBCEFCSW: Management and User’s Guide for
more information about port views.
Complete the following steps from the Faceplate window to set user preferences for your SAN Utility
sessions:
1. Click
File
򃵠
Preferences.
The Preferences window opens, as shown in Figure 22 on page 37.
Figure 22. Preferences window.
2. Type or browse to the paths to the working directory and browser.
3. In the
Application-wide Options area of the window, complete the following steps:
a. In the
Fabric discovery interval
field, select a polling frequency (30 seconds is the default value).
b. In the
View file auto save and load field, select Enabled or Disabled
.
c. In the
Preferred initial port view
field, select the port view mode for the Faceplate window.
4. Click
OK
to save your changes.