Functional Architecture
Intel® Server Board S5500WB TPS
24
Revision 1.9
Intel order number E53971-008
Figure 17. Installing Memory
4. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open
position (see letter ―A‖ in the figure above).
5. Holding the DIMM by the edges, remove it from its anti-static package.
6. Position the DIMM above the socket. Align the two small notches in the bottom edge of
the DIMM with the keys in the socket (letter ―B‖ in Figure 16).
7.
Insert the bottom edge of the DIMM into the socket (letter ―C‖ in Figure 16).
8. When the DIMM is inserted, push down on the top edge of the DIMM until the retaining
clips snap into place (letter ―D‖ in Figure 16). Make sure the clips are firmly in place
(letter ―E‖ in Figure 16).
9.
Replace the server’s cover and reconnect the AC power cord.
3.4.7.2
Removing DIMMs
To remove a DIMM, follow these steps:
1. Turn off all peripheral devices connected to the server.
2. Turn off the server.
3. Remove the AC power cord from the server.
4.
Remove the server’s cover.
5. Gently spread the retaining clips at each end of the socket. The DIMM lifts from the
socket.
6. Holding the DIMM by the edges, lift it from the socket and store it in an anti-static
package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the DIMM
sockets.
8.
Replace the server’s cover and reconnect the AC power cord.
Summary of Contents for S5500WB
Page 14: ......