Intel® Server System R2600SR Setup and Service Guide
37
3.8
Replacing the Drive Backplane
The drive backplane is located in the compute node between the rear of the drive bays and the back edge of
the server board.
3.8.1
Removing the Drive Backplane
Note: The drive backplane actually in the system may differ from those shown below.
Before removing the drive backplane, complete the following steps:
1.
Remove the compute node to be serviced (see Section 0).
2.
Remove the compute node cover (see Section 3.1.3).
3.
Pull the drives (or drive fillers) part of the way out of the node to disengage them from the drive
backplane (see Section 3.7.1).
Figure 31. Drive backplane cable reference
4.
Disconnect the ambient sensor, SAS/SATA, and power cables (see Numbers 1, 2 and 3 respectively)
from the backplane.
Summary of Contents for R2600SR Series
Page 2: ...Blank page...
