Hardware Installations and Upgrades
Intel
®
Server System R1000BB Service Guide
19
top cover, power down the server and unplug all peripheral devices and the power cable(s).
Note: A non-skid surface or a stop behind the server system may be needed to prevent the server
system from slding on your work surface.
1.
Observe the safety and ESD precautions at the beginning of this book.
2.
Turn off all peripheral devices connected to the server. Turn off the server.
3.
Disconnect the power cord.
4.
Remove the four screws (see letter "A").
5.
Slide cover back and lift upward (see letter "B").
6.
Figure 22. Removing the System Cover
Installing the System Cover
1.
Place the top cover on system and slide towards the front of chassis until the recessed front
edge is fully engaged. (see letter “A”).
2.
Install the three screws at the front and torque to 7-9in-lbs, then install the screw at the
back and torque to 7-9in-lbs. (see letter “B”).
3.
Figure 23. Installing the System Cover
