Intel PCH-LP, Programming Manual

Page: 56 / 90

56 523462
Intel Confidential
Flash Image Tool
7.3 PCH Soft Straps
These sections contain configuration options for the PCH. The number of Soft Strap
sections and their functionality differ based on the target PCH. Please refer to Appendix
A and the respective FW Bringup Guide.
7.4 Management Engine VSCC Table
This section is used to store information to setup flash access for Intel ME. This does
not have any effect on the usage of the Flash programming Tool (FPT) if the
information in this section is incorrect, the Intel ME Firmware may not communicate
with the flash device. See 4.4 Intel
®
ME Vendor-Specific Component Capabilities
(Intel
®
ME VSCC) Table . This information provided is dependent on the flash device
used on the system. for more information. Please contact your flash vendor for
information on the specific SPI flash device.
7.4.1 Adding a New Table Entry
To add a new table, right click on VSCC table and select add a new table entry.
The program will then prompt the user for a table entry name. To avoid confusion it is
recommended that each table entry be unique. FITc will not create an error message
for table entries that have the same name.
After a table entry has been added, the user will be able to fill in values for the flash
device. The values in the VSCC table are provided by your flash vendor. The
information in the VSCC table entry is similar to information that is displayed in the
Figure 7-8. Add New VSCC Table Entry
Figure 7-9. Add VSCC Table Entry