Hardware Installations and Upgrades
44
Intel
®
Server Chassis P4000M Service Guide
Figure 67. Two 8x2.5” Hot Swap Backplane Cable Connections
7. Install the air duct if the air duct is removed. For instructions, see “Installing the Airduct”.
8. Install the chassis cover. For instructions, see “Installing the Chassis Cover”.
9. Plug all peripheral devices and the AC power cable into the server.
10. Power up the server.
Removing and Installing 8x2.5'' Hotswap Backplane
Removing 8x2.5'' Hotswap Backplane
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Remove the front bezel if it is installed. For instructions, see “Removing the Front Bezel (Pedestal
Only)”.
5. Remove the 8x2.5'' Hotswap Hard drives cage. For instructions, see “Removing 8x2.5'' Hotswap Hard
Drive Cage Assembly”.
6. Remove the screw on the backplane (see letter
A
).
7. Push the backplane (see letter
B
) and remove the backplane from the cage (see letter
C
).
Summary of Contents for P4000M
Page 14: ......
