Intel® Server Board M50CYP2SB Family Technical Product Specification
53
5.1.1
Configuring System Management Port Using <F2> BIOS Setup
1.
During the system power-on POST process, press
<F2>
when prompted to go to the BIOS Setup
utility main menu page.
2.
Navigate to the
Server Management
tab and select
BMC LAN Configuration
to enter the BMC LAN
Configuration screen (
Figure 28. BIOS Setup BMC LAN Configuration Screen
3.
The system is configured using the
BMC Dedicated Network Configuration
4.
For an IPv4 network:
o
If configuring the server management BMC LAN, scroll to
Baseboard LAN configuration
>
IP
source
and then select either
Static
or
Dynamic
. If
Static
is selected, configure the
IP address
,
Subnet mask
, and
Gateway IP
as needed.
5.
For an IPv6 network:
o
If configuring the server management BMC LAN, scroll to
Baseboard LAN IPv6 configuration
>
IP
source
and then select
Enabled
. Then scroll to
IPV6 source
and select either
Static
or
Dynamic
. If
Static
is selected, configure the
IPV6 address
,
Gateway IPV6
, and
IPV6 Prefix Length
as needed.
6.
The default
User Name
and
Password
is
admin/admin
.
7.
If there is a need to change the User and Password, select
BMC User Settings
to enter the User
Configuration screen (
8.
Under
Add User
, set the following settings as desired:
o
User Name
–
Enter the desired name. Note that the anonymous user cannot be changed.
o
User password
–
Enter the desired password twice.
o
Channel No
–
Select the Channel
o
Privilege
–
Select the privilege to be used. (Administrator privilege is required to use KVM or
media redirection)
9.
Press
<F10>
to save the configured settings and exit BIOS Setup. The server reboots with the new
LAN settings.
