3.
Orient the processor with the heat spreader side down so its alignment features match those of the
carrier clip as shown in the following figures.
Figure 19. Processor Carrier Assembly
4.
Install the processor into the processor carrier clip until it snaps into place.
Figure 20. Processor Carrier Clip Sub-Assembly
CAUTION:
A processor can dislodge from the processor carrier clip if the assembly is grasped by
the long narrow edges of the processor clip. The processor carrier assembly should only be
grasped using the shorter edges of the assembly.
5.
If present, remove the protective film covering the TIM on the bottom side of the heat sink.
