Intel D845GEBV2 - OCTOBRE 2002, Quick Reference, Page: 6 / 48

6 Intel Desktop Boards D845GERG2 and D845GEBV2
Quick Reference
Memory Module Requirements
The desktop board supports system memory as defined below:
•
Up to two 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory
Modules (DIMMs) with gold-plated contacts. Supported memory
configuration are:
—
DDR333: to run DDR333 memory at full speed requires an Intel
Pentium 4 processor with 533 MHz front side bus frequency (FSB).
DDR333 memory will run only at DDR266 speeds when using a
processor with 400 MHz FSB.
—
DDR266: requires an Intel Pentium 4 processor with 533/400 MHz
FSB, or Intel Celeron processor with 400 MHz FSB.
•
Unbuffered and non-registered single or double-sided DIMMs
•
Serial Presence Detect (SPD) memory only
•
Non-ECC RAM (ECC memory will run in non-ECC mode)
•
2.5 V memory
✏
NOTES
Desktop Boards D845GERG2 and D845GEBV2 have been designed to
support DIMMs based on 512 Mbit technology up to 2 GB, but this
technology has not been validated on these boards.
All memory components and DIMMs used with the desktop boards must
comply with the PC SDRAM specifications. These include the PC
SDRAM Specification (memory component specific), the PC Unbuffered
DIMM Specification. To view or download these specifications, refer to
this Intel World Wide Web site:
http://www.intel.com/technology/memory/pcsdram/
For information about vendors that support these memory requirements,
refer to the Desktop Boards D845GERG2 and D845GEBV2 link on this
Intel World Wide Web site:
http://support.intel.com/support/motherboards/desktop/