Intel® Server D50TNP Family Integration and Service Guide
181
Figure 268. Removing the System Fan
1.
If present, remove the power supply (see
Section 7.11
) from the system fan assembly to be removed.
2.
While pushing the green latch in the shown direction (see Letter A), use the handle to pull the system fan
assembly out of the bay (see Letter B).
Figure 269. Installing the System Fan
3.
Ensure no power supply is pre-installed in the system fan assembly.
4.
Insert the system fan assembly into the open fan assembly bay (see Letter A).
Note:
80 mm fans must be installed on the sides (air-cooled system only); 60 mm fans must be installed
in the three center bays.
5.
Push in the system fan assembly until it locks into place.