Intel BLKDH57DD, Technical Product Specification

Page: 70 / 88

Intel Desktop Board DH57DD Technical Product Specification
70
4.3 Front-panel Power LED Blink Codes
Whenever a recoverable error occurs during POST, the BIOS causes the board’s front
panel power LED to blink an error message describing the problem (see Table 43).
Table 43. Front-panel Power LED Blink Codes
Type Pattern Note
F2 Setup/F10 Boot Menu
Prompt None
BIOS update in progress Off when the update begins, then on for
0.5 seconds, then off for 0.5 seconds. The
pattern repeats until the BIOS update is
complete.
Video error (no add-in
graphics card installed) On-off (0.5 second each) two times, then
3.0-second pause (off), entire pattern repeats
(blink and pause) until the system is powered
off. For processors requiring an
add-in graphics card
Memory error On-off (0.5 second each) three times, then
3.0-second pause (off), entire pattern repeats
(blinks and pause) until the system is powered
off.
Thermal trip warning Each beep will be accompanied by the following
blink pattern: .25 seconds On, .25 seconds Off,
.25 seconds On, .25 seconds Off. This will result
in a total of 32 blinks.
4.4 BIOS Error Messages
Table 44 lists the error messages and provides a brief description of each.
Table 44. BIOS Error Messages
Error Message Explanation
CMOS Battery Low The battery may be losing power. Replace the battery soon.
CMOS Checksum Bad The CMOS checksum is incorrect. CMOS memory may have been
corrupted. Run Setup to reset values.
Memory Size Decreased Memory size has decreased since the last boot. If no memory
was removed, then memory may be bad.
No Boot Device Available System did not find a device to boot.