Turning On & Basic Operations
En-27
Using Remote Playback
Note
• Remote playback cannot be used in any of the following cases:
– Network services are being used.
– Contents are being played from a USB device or iPod/iPhone.
– Zones are turned on.
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can also change the frequency steps (
Tuning into Radio Stations
■
Auto tuning mode
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
5
Click “OK” to close the dialog box.
This completes the Windows Media Player 12
configuration.
You can now play the music files in your Windows
Media Player 12 library.
Tip
• On the “Stream” menu, confirm that “Allow remote control
of my Player...” is checked.
1
Turn on the AV receiver.
2
Start Windows Media Player 12.
To enable remote playback, you must first configure
Windows Media Player 12.
3
On Windows Media Player 12, right-click on a
music file.
The right-click menu appears.
Tip
• For selecting another media server, select the desired media
server from the “Other Libraries” menu on Windows Media
Player 12.
4
Select the AV receiver in “Remote playback”.
The “Play to” window appears and playback on the
AV receiver starts. Operations during remote playback
can be made from the “Play to” window of Windows 7
on your personal computer.
A playback screen will be displayed on the connected
TV.
5
Adjusting the Volume.
You can adjust the volume by adjusting the volume
bar in the “Remote playback” window. The default
maximum volume level is 64. If you wish to change
this, enter the value from the Web Setup in your
browser. Refer to step 3 of “Registering Other Internet
Radio” for details (
The volume value of the remote window and the
volume value of the AV receiver may not always
match.
Adjustments you make to the volume in the AV
receiver will not be reflected in the “Remote
playback” window.
Listening to AM/FM Radio
This section describes the procedure of using the
buttons on the front panel, unless otherwise specified.
1
Press
AM
or
FM
to select either “AM” or “FM”.
In this example, FM has been selected.
(Actual display depends on the country.)
Band
Frequency
1
Press
Tuning Mode
so that the AUTO indicator
lights on the AV receiver’s display.
2
Press
Tuning
q
/
w
.
Searching stops when a station is found.
When tuned into a station, the
TUNED
indicator
lights. When tuned into a stereo FM station, the
FM
STEREO
indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
1
Press
Tuning Mode
so that the AUTO indicator
goes off on the AV receiver’s display.
2
Press and hold
Tuning
q
/
w
.
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
TUNED
FM STEREO
AUTO