DPS-10.5
SERVICE PROCEDURES-2
Factory-shipped condition
Push button "ON" (Mechanical SW) Except
<DC1N>
Press the [
STOP
] and [
STANDBY
] same time.
(Wait until FL display "No Disc") .
Push button "
STANDBY
".
INITIALIZING
Others
SURR. MODE Switch -------- "1" position
Mechanical power switch ---- ON
2. Safety-check out
(Only U.S.A. model)
After correcting the original service problem perform the
following safety check before releasing the set to the customer
Connect the insulating-resistance tester between the plug of
power supply cord and terminal GND on the back panel.
Specifications: More than 10M ohm at 500V
Confirm version of Microprocessor
At power ON.
1. Press "
DISPLAY
" key and "
VIDEO OFF
" key at same time.
2. Press "
DISPLAY
" key.
a) System microprocessor
b) Release version of System microprocessor
c) Loader microprocessor version
d) B/E version of microprocessor
e) F/E version of microprocessor
g) FL display microprocessor
h) Video microprocessor
i) Loader of video microprocessor
j) iLINK microprocessor
k) Model name
l) Destination
m) All segment of TL tube
Regional cod is displayed on the TV monitor.
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299