Commissioning, Operation and Configuration
ETSM
ETSM / ETSU
38
10.4.4
Traps
Traps are used to signal failure conditions of the device. Traps are data packets that
are sent to a configured network address via the network. This allows a monitoring
at the destination address.
The content of the data packet consists of two bytes which contains the current
failure condition code (refer to failure conditions).
Please note that these are no SNMP traps, but specific failure codes.
The following settings can be made in the web interface under
Configuration >
System
:
•
Activate / deactivate traps (default: activated)
•
Protocol: TCP, UDP (default: UDP)
•
Destination IP address (default: 192.168.0.1)
•
Destination port: (default: 4321)
One or more of the following failure conditions can be configured as trigger of the
traps:
•
Power (active as default)
•
Temperature (active as default)
•
Link down (active as default)
•
Internal (active as default)
•
Digital input