15
What are the bristles made of?
A. The bristles are made of heat resistant nylon.
What is the power of the InStyler?
A. The InStyler is 220-240V, 50Hz and 35 Watts.
How do I turn the InStyler on?
A. Check to make sure your InStyler is plugged in. Press the Power button. The LED bars
should light and begin flashing. Once the LED stops flashing the InStyler is ready to go.
You must close the handle to begin the rotation.
How do I get my InStyler to rotate?
A. You must close the handle to start the rotation. The rotation will start automatically.
What if my InStyler does not heat?
A. Check to make sure your InStyler is plugged in. Press the Power button. The LED bars
should light and start flashing. When the LED stops flashing the InStyler will be at the
set temperature and ready to use.
When I use my InStyler, why does the temperature LED start to flash?
A. It is normal for the heat to fluctuate during use. As long as the InStyler has been
allowed to reach full heat (steady LED) after powering on, you can continue to use
your InStyler while it is flashing.
Ho do I clean my InStyler?
A. When cleaning your InStyler, disconnect it from the power source and make sure it
has completely cooled. Wipe the outside surface only with a soft damp cloth.
Be sure to wring out all excess water before applying it to the InStyler. Clean more
severe dirt by using a soft, damp cloth with a mild soap. Bristles can be lightly
scrubbed if necessary with a damp cloth to remove any built up product and any
residual hair left in the bristles should be removed. The barrel can be wiped down
with a soft, damp cloth. Use a mild soap if necessary. Make sure the InStyler is
completely dry before plugging into any power source.
