Instron 34FM-100, Preinstallation Manual

Page: 19 / 76

19
System Safety and Information Labeling
Product Support: www.instron.com
•
Limit stops - these must be set before each test session to protect the operator and
load string components against unexpected crosshead movement.
•
Frame control panel - holds all the controls and indicators for the testing system.
Software
Control of the testing system is carried out via Instron Bluehill
®
software. Setting test
parameters, operating the system, and collecting test data is done through the software
program.
System Safety and Information Labeling
Table 3 on page 19 explains the meanings of any safety and information labels that
may be attached to any part of the testing system.
Table 2. Software Terminology
Term Description
Test Method In
Bluehill
®
software, a test method is a file that contains a set of defined
parameters that the system uses to run tests, analyze the test data, and
produce calculated results.
Sample A group of material specimens, whose properties are studied and
compared to gain statistical or quality assurance information. For
example, you could take a specimen from different parts of a single
manufacturing run of a material to form a sample of the material. The
sample is then representative of the complete run and you can test it to
ensure that the material quality has remained stable over the complete
run. You perform the same test on each specimen in a sample.
Table 3. Safety and Information Labeling Descriptions
Label Meaning Purpose
Electrical
hazard Indicates that an electrical hazard exists
from high voltage and/or electrical current.