Chapter 4: Maintenance
54
M47-17035-EN
Remove and install console covers
To perform any maintenance on the HPS it is necessary to remove the rear cover from the console.
Loosen and remove the seven M6 button head cap screws (2,
) from the rear cover (1). Be
careful of the electrical wires to the fan. If necessary, the wires can be disconnected at their connections.
When installing the cover, tighten all cap screws until fully seated. The only equipment required is a 4 mm
hex key (supplied).
Figure 11. Components of rear cover.
2
1
1. Rear cover
2. M6 button head cap screw
