Parts List:
Description
Qty.
Frame assembly with seat,
canopy, and wrist strap
1
Front Wheel
1
Parent Console
1
Under-seat Basket
1
Rear Wheels
2
Front Fender
1
#8 – 11.2" Phillips head screws
4
Tools Required:
Phillips screw driver, adjustable wrench.
Stroller Assembly Instructions
Unfold Stroller: Remove from carton, and remove any packaging materials that
may be holding the frame in closed position. Grasp the handle and open the
frame. The stroller will lock into place. To ensure the stroller is locked, push the
handle down lightly. Be sure the stroller is locked in place before placing a child
in the stroller.
Rear Wheel Assembly
Grasp rear wheel in one hand, slide wheel’s axle into hole in rear of frame. Push
up on the axle release lever so that the wheel is fully inserted. Pull the wheel
firmly, the wheel should not come off if fully inserted/locked. Repeat for other
side. To release wheel push up on axle release lever and pull off wheel.
Front Wheel Assembly
Tip stroller back so that the handlebar is down on the ground and the front fork
is up. Attach the front wheel by loosening the wheel’s Quick Release (Q/R) lever
on the front wheel far enough to allow the axle to slide into the front fork. With
wheel’s Q/R lever in open position, hand tighten the cone nut until almost tight,
then flip wheel’s Q/R lever backward to the closed position to lock wheel in
place. Note this step may require minor adjustment until the Q/R lever flips back
with firm pressure. Pull outward on wheel to ensure it is locked in place.
Caution:
The interior jam nuts are factory installed and do not need adjustment.
Close the front caliper brake by lowering the Q/R lever. Spin the front wheel
to make sure the brake pads do not rub and are properly aligned to the rim. If
brake pad alignment is off, loosen brake pad nut with an adjustable wrench,
align brake pad and retighten nut while holding brake pad in place.
Caution:
Always be sure to reengage the brake by rotating the Q/R lever
forward (toward the front wheel) before using the stroller.
IMPORTANT
If you notice that the stroller steers to one direction you may need to adjust the
front wheel to align it. To do so loosen the front axle Q/R lever, points the front
wheel in the opposite direction the stroller is veering, and retighten the Q/R lever.
If you need help making this adjustment, please call our Customer Service
department for assistance.
Operating Instructions
Run Around
™
11-BA101, 11-BA102...page 2
Front Wheel Assembly
quick-release
lever
(open position)
Rear Wheel Assembly
M3_single_Platform.indd 3
9/26/05 3:57:43 PM
