Your new INSTEON
TM
Lamp Dimmer allows you to dim and remotely control any
lamp in your home at the touch of a button.
HINTS
• Do not use an outlet controlled by
a switch
• Be sure to leave the lamp's local
switch in the on position
• Use to control incandescent
bulbs only.
Quick-Start Guide
LAMP DIMMER
Pass-through
Outlet
Controlled
Outlet
Set Button
Status LED
Installing Your Lamp Dimmer
Smarthome Limited Warranty
Smarthome warrants to the original consumer of this product that, for a period of two years from the date of purchase, this product will be free from defects in material and workmanship and will
perform in substantial conformity to the description of the product in the owner's manual. This warranty shall not apply to defects or errors caused by misuse or neglect.
© Copyright 2005 Smarthome, 16542 Millikan Ave., Irvine, CA 92606-5
5027
800.SMART.HOME - 949.221.9200 - www.smarthome.com
S
Stteepp 1
1..
Two Signal Enhancers (SignaLinc
TM
RF #2442) must be installed if your home does not already have them.
S
Stteepp 2
2..
Plug your lamp into the outlet at the bottom of the Lamp Dimmer (labeled "Controlled").
S
Stteepp 3
3..
Plug your Lamp Dimmer into an unswitched wall outlet.
S
Stteepp 4
4..
If lamp is off, turn it on.
S
Stteepp 5
5..
Select the INSTEON Controller you would like to use and set it to Linking Mode. Refer to your INSTEON
Controller’s User’s Guide for detailed instructions.
For Models: LampLinc
TM
V2 2-pin (#2456D2)
LampLinc
TM
V2 3-pin (#2456D3) -
pictured
NOTE: The following will work for most INSTEON Controllers.
• On the INSTEON Controller, choose the ON/OFF Button Pair you want to use for controlling your Lamp
Dimmer.
• Set the INSTEON Controller to Linking Mode by pressing and holding the ON Button of the pair for 10
seconds.
N
Neeeedd H
Heellpp?? FFoorr aassssiissttaannccee ccaallll yyoouurr ffrriieennddllyy IIN
NS
STTEEO
ON
N
ssuuppppoorrtt ppeerrssoonn @
@ 8
80
00
0-S
SM
MAAR
RTTH
HO
OM
MEE ((8
80
00
0-7
76
62
2-7
78
84
46
6))
S
Stteepp 6
6..
Press and hold the black Set Button on the Lamp Dimmer for 3 seconds. The lamp you are controlling will
blink to confirm linking. Depending on the INSTEON Controller, you have about 4 minutes to perform this
step before setup mode times out automatically.
Congratulations! You can now dim and remotely control your lamp.
