Go to http://install.instar.com
6-EN
4.3. Status LEDs
01 - Photosensor
Twilight switch for IR LEDs
02 - Lens
Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
03 - Infrared LEDs
12 IR LEDs (nightvision @ 850nm)
04 - PIR Detector
Integrated passive infrared motion detector
05 - Loudspeaker
Integrated loudspeaker
06 - Microphone
For noise detection / audio rec. / two-way audio intercom
07 - Power Connector
5V / 1.5A DC - Plug Ø : 1.35mm (in) / 3.5mm (out)
08 - Status LED
blue: network status (can be turned on/off)
Please refer to below Chapter 4.3 Status LED
09 - WPS / Reset
3 seconds for quick WiFi setup / 15-20 seconds for reset
10 - Antenna Connector SMA connector (incl. 2,4dB antenna / not for PoE version)
11 - Network Port
RJ45 LAN-port / connector for Cat5e LAN cable or higher
12 - Audio Output
3.5mm jack for earphone / active speaker
13 - MicroSD Card Slot
Slot for MicroSD/SDHC cards (max. 32GB - 8GB included)
14 - Mount
Standard camera thread for included bracket (1/4”-20 UNC)
15 - Camera Label
P2P ID, LAN MAC address and serial number
Status LED
Blue LED
Green LED
Orange LED
Constant on
Booting process
-
Network cable is con-
nected or in WiFi mode
Slow Flashing
LAN connection
-
-
Fast Flashing
WiFi connection
Data transfer
through LAN
-
Off
Firmware update
in process or
LED is turned off
No network cable
connected or in
WiFi mode
Network cable is not
connected correctly
