Go to http://install.instar.com
6-EN
4.3. Status LEDs
01 - Photosensor
Twilight switch for IR LEDs
02 - Lens
Focal length: 8mm / field of view: ~ 45º dia.)
03 - Infrared LEDs
10 IR LEDs (nightvision @ 850nm)
04 - Loudspeaker
Integrated loudspeaker
05 - SD Card Slot
Slot for SD/SDHC cards (max. 32GB - 4GB included)
06 - Microphone
For noise detection / audio rec. / two-way audio intercom
07 - Status LED
blue: network status (can be turned on/off)
Please refer to below Chapter 4.3 Status LED
08 - Alarm input/output
Input for potential free external alarm sensors
Output (relay) can support max. 24V/1A
09 - Audio input/output
Audio input: for optional external microphone
Audio output: 3.5mm jack for earphone / active speaker
10 - Network Port
RJ45 LAN-port / connector for Cat5e LAN cable or higher
11 - Antenna Connector SMA connector (incl. 2,4dB antenna / not for PoE version)
12 - Power Connector
5V / 1.5A DC - Plug Ø : 1.35mm (in) / 3.5mm (out)
13 - WPS / Reset
3 seconds for quick WiFi setup / 15-20 seconds for reset
14 - Mount
Standard camera thread for included bracket (1/4”-20 UNC)
15 - Camera Label
P2P ID, LAN MAC address and serial number
Status LED
Blue LED
Green LED
Orange LED
Constant on
Booting process
-
Network cable is
connected or in WiFi
mode
Slow Flashing LAN connection
-
-
Fast Flashing WiFi connection
Data transfer through
LAN
-
Off
Firmware update in
process or LED is
turned off
No network cable
connected or in WiFi
mode
Network cable is not
connected correctly
