5
Failure to connect the overflow-outlet to a permanent waste or drain, could lead to property damage
from flooding.
Whilst every reasonable precaution is taken to prevent an overflow, Instanta cannot be held responsible for any damage
caused as a result of incorrect installation or blockage of the overflow or failure to direct the overflow to a safe outlet.
OPERATION
First Use
(once water and electrical connections have been made);
•
Switch boiler on.
The screen will light up red and will run through an initial self-diagnostic check before starting
to fill with water (screen
reads; “NOT READY FILLING”).
•
Once primed with water,
the boiler will begin to heat (screen reads; “NOT READY HEATING”).
•
When the correct temperature has been reached, the display will change from Red to White
and will simply read “READY”
.
•
The boiler will then continue in a heat/fill cycle until the tank is at full capacity. (During the
heat/fill cycle, small amounts of water are added to ensure the water at the tap is always at the
correct temperature).
IMPORTANT NOTE
: In normal daily use, the boiler may be used as soon as the “READY” message
is displayed, but on first install, wait at least 15 minutes before starting to use.
•
The boiler is now ready for use.
REGULAR DAILY USE
Switch boiler on and wait for the screen to turn white and show “READY” message. The water will then
be at the correct temperature.
Dispense water via the lever tap. (CAUTION: Boiler dispenses near-boiling water).
SETTING & ADJUSTING FILTER MONITOR (Optional):
The unit as a built-in optional filter monitor. This monitor can be used with any external water filter or
softener. To turn this option on as below:
-
Turn machine off.
-
Press & hold “on/off” button (for approximately 12 seconds) until red screen shows “PR” in top
-
right corner, then release button. Temperature setting is displayed.
-
Press & hold button (long push) for approximately 5 seconds until screen changes to show
“
Empty Filter Symbol
” (default filter setting
- OFF).
-
Press button (short push) to scroll between the different filter settings;
SOFT
MEDIUM
HARD
EMPTY FILTER SYMBOL (No Filter monitor)
Hard and Soft Water: The effectiveness of the filter will be
reduced in hard water areas
(and should be
replaced more frequently), or
extended in soft water areas
where scale is less of a problem.
-
With the required filter setting selected, Press & hold button (long push) for 4 seconds to save.
-
Press & hold button (long push) for approximately 6 seconds until display goes blank.
-
Turn machine back on again.
