Rack-Mounted Server Installation Guide
V1.0
Rail-Kit Contents
Installing the Rails
1
1
2
Align the pins on the front bracket to the front of the rack. Press the locking
latch as indicated by arrow ①, and then insert the pins as indicated by
arrow ② until the pins are fully engaged.
3
Repeat Step 1 and Step 2 for the other rail.
NOTE:
The front end and the rear end of the rail, and the two rails MUST be
installed at the same height.
4
Align the server with the rails, and slide the chassis all the way into the rack.
Removing the Rails
Align the pins on the rear bracket to the desired position of the back of the
rack. Press the locking latch as indicated by arrow
①
, and then insert the
pins as indicated by arrow
②
until the pins are fully engaged.
Open both handles on the front of the server, and then tighten the two
thumb screws.
2
Slide the server out, and then remove
the server from the rack.
3
Disengage the pins from the rack.
5
Open both handles on the front of the server, and then loosen the two
thumb screws.
Outer Rail
Back-Sliding Rail
Front Bracket
Rear Bracket
1
2
1
2
1
2
3
4
Locking
latch
Locking
latch
Rail
3
