Pull the white tab forward and take out the inner rail.
Caution:
Do not over bend the spring plate to avoid damage.
Installing the rails
1
2
3
➊
➋
→
Position the rail on the rack. Fix the rear bracket first, and lock the matching screws
and washers on the screw holes, then lock the screws on the front bracket. Install the
other rail in the same way.
Notice:
Keep the front and rear brackets at the same height, and keep the two rails
on the same level.
Pull the middle rails fully extended in lock position. Lift the server, align the inner rails
with the middle rails, and push the server slowly until it hits a stop.
Installing the server
1
Removing the rails
1
Pull down the covers of the left and right lugs, and tighten the screws within.
3
Pull or push the blue release tab, and push the server inward until the inner rails fully enter
the middle rails. Press the two tabs on the middle rails while pushing the server into place.
2
➊
➌
Click
➋
➋
➊
➋
Inner rail
Middle rail
Outer rail
white
Align the keyholes on the inner rail with the standoffs on the chassis, and push the rail
in the direction of the arrow to install the inner rail onto the chassis.
Front bracket
Rear bracket
blue
Remove the screws within the left and right lugs. Pull the server outwards
until the tabs on the middle rails are locked.
Pull the white tabs on the inner rails in the direction of the arrow, and
remove the server from the rack.
Slightly lift up the keyhole spring plates, and slide the inner rails forward to
remove the inner rails.
V1.0
Rack-Mounted Server Installation Guide
