19
E05
Over
current
protection:
treadmill is running, control
board check the current is over
standard current +6A for 3
seconds
Treadmill cannot start, warning sound 9times.
Console show the E05. If treadmill can restart in 10
seconds, it will be ok.
Solution: current is over the standard current, so
system take protection. Or some part cannot work;
causing the motor cannot run normally. Recheck the
treadmill, and restart the treadmill. Check if the bad
smell, change motor, or control board has. Recheck
the current is right or not.
E06
Over
explosion
protection:
voltage is not correct or motor
not work well, cause motor wire
bad.
Treadmill cannot start, warning sound 9times.
Console show the E06. If treadmill can restart, it will
be ok.
Solution: check the voltage is lower than 10%
standard voltage, using the correct voltage to check
again. Check control board smelling, if burnt smell,
change control board. Check the motor wire
connection, reconnect.
TREADMILL MAINTENANCE
Proper maintenance is very important to ensure a faultless and operational condition of the treadmill.
Improper maintenance can cause damage to the treadmill or shorten the life of the product.
All parts of the treadmill must be checked and tightened regularly. Worn out parts must be replaced
immediately.
1. Lubrication:
The treadmill is factory-lubricated. However, it is recommended to check the lubrication of the
treadmill regularly, to ensure an optimal operation of the treadmill. It is usually not necessary to
lubricate the treadmill in the first year or the first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel the surface of the belt, as
far as possible. If traces of silicon spray are found, lubrication is not necessary.
In case of a dry surface refer to the following instructions.
Only use oil free silicon spray.
2. Application of lubricant on the belt:
Position the belt so that the seam is located in the middle of the plate.
Insert the spray valve in the spray head of the lubricant container.
Lift the belt at one side and hold the spray valve in a distance to the front end of striding belt
and plate. Start at the front end of the belt. Lead the spray valve in direction of the back end.
Repeat this process on the other side of the belt. Spray each side for about 4 seconds.
Wait 1 minute to let the silicon spray spread, before starting the machine.
3. Cleaning:
Regular cleaning of the striding belt ensures a long product life.
Warning: The treadmill must be turned off to avoid electrical shocks. The power cord must be
pulled out of the socket, before starting the cleaning or maintenance.
After each training: Wipe the console and other surfaces with a clean soft and damp cloth to
remove sweat residues.
Caution: Do not use any abrasives or solvents. To avoid damage to the computer, keep any
liquids away. Do not expose the computer to direct sunlight.