Insportline Gardian G12, User Manual

Page: 18 / 27

18
POWER SAVING MODE
This device has a power saving function. It will automatically enter power saving mode after 4 minutes
without any activity. The display will shut down. To turn it on again, press any key.
MP3
While the machine is turned on, connect a MP3 device or another audio device. You can play music
on the control panel.
1. When you plug a SD card or a USB, the volume and song selection is done through the
control panel.
2. When you connect the machine to an external MP3 device, the volume and song selection is
done on the device itself.
METRIC-INCH SYSTEM CHANGE AND INCLINE ADJUSTMENT
A. Press the
“START” button and pull out the safety key. Then connect the safety key again and
you can set the metric/inch system with the
“SPEED +” or “SPEED -“ buttons. Select either
“SI” (metric system) or “Eng” (inch system) in the speed window. Then press “START” to
confirm and the machine will enter the standby mode.
B. While in the standby mode
, press “SPEED +”, “SPEED -“, “I”, “INCLINE -“ button at
the same time for 3 seconds and enter the automatic incline adjustment. After you finish, the
device will enter the standby mode.
TROUBLESHOOTING (DISPLAY ERRORS)
Er-1: Power on, no computer reaction

Check the computer power line.

Check the connections between the computer and the controller.
Er-2: Incline system failure

Check the signal line of the incline motor.

Check if the incline motor is damaged.

Check if the controller is damaged.
Er-3: Over-voltage protection.

Make sure the power voltage is in the optimal range: AC220-240V.
Er-4: Over-current protection

Check if the moving parts
of the treadmill aren’t stuck.

Check the state of oil. Insufficient lubrication can increase the friction between the running belt
and the running board.

Check whether the running belt or running board is worn.

Check the controller or motor for damage.
Er-5: Over-load protection

Check if the moving parts are stuck.

Check the state of lubrication. If there is insufficient lubrication, it can increase the friction
between the running belt and the running board.

Check the running belt or the running board for wear.

Check the controller or the motor for damage.