Insportline 19892, User Manual

Page: 42 / 51

42
MAINTENANCE INSTRUCTIONS
WARNING: Please make sure the treadmill's is pulled out of the power supply before cleaning or
maintenance.
1. CLEANING (Fully cleaning will lengthen the usage of the treadmill.)
Keep the treadmill clean by dusting it regularly. Be sure to clean the exposed parts on both sides of
the running belt, which can reduce the piling of dust under the it. Make sure your shoes are clean and
avoid putting things onto the running belt. It could damage both the running belt and the running deck.
The top of the belt needs to be cleaned with a wet, soapy cloth. Be careful to keep any liquid away
from the electrical components and the underside of the running belt.
WARNING: Remember to unplug the treadmill from the electrical outlet before removing the motor
cover. Remove the motor cover and vacuum under the motor cover at least once a year.
2. LUBRICATION (Running belt and the special lubricating oil of the motorized treadmill.)
This treadmill's running belt and deck are already pre-lubricated. The belt/deck friction may play a
major role in the function and life of your treadmill, thus requiring regular lubrication. We recommend a
inspecting the deck regularly. If the deck is worn, please contact our client service centre.
Recommended lubrication of the running deck and the running belt:
•
Low use (lower than 3 hours per week)
– once per year
•
Moderate use (3-5 hours per week)
– every 6 months
•
Frequent use (more than 5 hours per week)
– every 3 months
•
Always use silicon oil inSPORTline.
MAINTENANCE GUIDELINES
•
In order to maintain and prolong the working life of your treadmill, we suggest that you power
off for 10 minutes after every 2 hours of running.
•
A loose running belt will slip when you are running; a too tight running belt will affect the
performance of the motor and may also increase the wear of the rollers and the running belt.
The ideal position is if you can lift the belt from the running deck to about 50
– 75 mm.
BELT MIDDLE PLACEMENT AND TIGHTNESS ADJUSTMENT
It is necessary to adjust the belt to the best condition for the better use of the treadmill. Put the
treadmill running belt at the centre. Put the motorized treadmill on the level ground and let the treadmill
run at the speed of 3 km/h. Observe the deviation of the running belt. If the running belt deviates to the
right, pull off the safety key and unplug the power. Turn the right adjusting bolt clockwise by 1/4 turn,
plug in the power cord and the safety key
– belt starts to run. Watch the running belt deviations.
Repeat the above steps until the running belt is in the middle.
•
Picture A If the running belt drifts to the left, pull off the safety key and unplug the treadmill
from power. Turn the left adjusting bolt clockwise by 1/4 turn, then plug in the power cord and
the safety key. The belt starts running. Watch if the belt still drifts to the side . Repeat the
above steps until the running belt is centred.
•
Picture B. After the above adjustment or long time use, the running belt could become loose
and you will need to adjust it. Pull off the safety key and the power cord and turn the left and
right adjusting bolts clockwise by 1/4 turn. Plug the treadmill back into power and insert the
safety key
– the belt starts running. Then stand on the treadmill to confirm its tightness.
Repeat the above steps, until the running belt is tightened correctly (picture C).