4
January 2017
ASSEMBLY OF CHAIR
Assembling the Back Support:
1. One by one, pull on each of the pull tabs and
change the pivot angle to vertical (Fig. 1).
Insert the U-shaped stainless steel back and
calf frames into the pivots and fasten with
bolts and nuts provided.
2. Insert the ends of the angle adjustment pull
handles into the small holes located on the
pull tab on each side of the frame (Fig. 2).
Firmly press the stainless steel caps
over the ends of the pull handle. Please
ensure that the end cap fi ts tightly over
the groove on the pull handle. Test it by
tugging at the cap. If it comes off, then
reinstall.
Figure 2
Figure 1
A - Back angle adjustment pull handle
B - U-shaped back support frame
C - Insertion point for back frame
D - Back angle adjustment pull tab
E - U-shaped calf support frame
F - Calf angle adjustment pull handle
G - Leg frame (can be positioned at
0°, 30°, 60° angles, relative to seat’s
horizontal plane)
H - Leg frame adjustment pull handle
Back
Frame
Pull Tab
Bolt
