12
Inspire Home Automation
www.insiprehomeautomation.co.uk
Installation & User manual
Install the Thermostat
Using your new Thermostat
Now that your wall mount and wiring is complete, it is time to finish the installation by
mounting your thermostat.
1. Install the supplied batteries into the back of your Thermostat and check the
screen illuminates.
2. Start the securing screws off before placing it onto the wall. This will make it
easier to install. Be sure the screws do not protrude into the Thermostat.
3. Carefully slide your thermostat over the wall mount taking care not to damage
the spring pins at the back. Do not force the Thermostat at this stage, if the
Thermostat does not slide easily check the following:
° Securing screws do not protrude into the Thermostat.
° The wiring cover is correctly installed.
° Wall mount screws are the correct size.
4. Secure the Thermostat by holding in place and lightly tighten the screws
underneath to secure the unit.
Do not over tighten.
If you have previously followed the instructions to activate your account then you have
finished installation and your Inspire Thermostat will be ready to use.
1. Make sure your Gateway box is connected and switched on.
2. Using your online account or through the mobile app. Test your thermostat
by setting the preferred temperature and turning your heating to ‘ON’.
3. Your Thermostat should respond within 10-20 seconds.
Congratulations! You’re all done.
If you have not yet activated your account please
see the ‘Activation’ part of this guide.
