You now have the right hand side panel in place and the right hand
rear panel. The next stage is to take the centre column control
panel and screw to the right hand rear glass frame. Again, repeat-
ing the procedure as before drill through pre-marked slots carefully
making sure not to drill too far or to mark rear panel. Place the top
and bottom plastic trim strips on the column using a fine bead of
silicone to seal and hold in place. On the bottom of the lower trim,
silicone seal and press into place on the tub. Screw column to the
side panel.
For the latest fitting instructions please visit
www.insigniarange.co.uk
Now you have attached the three panels, work your way round re-
peating the same process attaching the right back panel and side
glass right hand side. Seal as before.
The shower bath cabin will now have both the sides and back rear
panels on.
Taking the bottom front cross bar that will form the support and
the runner for the door and front glasses. Screw into left hand side
panel through the two holes. Seal under the crossbar where it will
mate with tub. Make sure this is fully sealed from one end to the
other. Now secure the same way but through the right hand side
panel. Repeat this operation again now using the top cross bar sup-
port. NOTE: The wider crossbar fits to the top, check picture of pro-
file. Notice lip for roof to fit inside. Notice curve in runner for door
wheels. Bottom crossbar profile as shown the curve will be to-
wards the top.
For the latest fitting instructions please visit
www.insigniarange.co.uk
19 20
Top crossbar profile
curve at the bottom
Bottom crossbar profile curve at top
