Insignia NS-P2000, User Manual

Page: 8 / 40

8
www.insignia-products.com
Electrical connections
Specifications
Amplifier
RMS power @13.8VDC
Power @ 4 Ohms............................... 200W × 2
Power @ 2 Ohms............................... 300W × 2
Bridged power @ 4 Ohms ................. 500W × 1
Minimum speaker impedance .............. 2 Ohms
THD distortion ....................................... 0.08%
IMD distortion ........................................ 0.08%
Frequency response ............................. 20 Hz to 20 KHz
Input sensitivity ..................................... 200mV to 6V
Input impedance ................................... 15K Ohms
Signal-to-noise ratio ............................. 90dB
Item Name Function or Control
A POWER/
BATTERY • +12 Volts - Connect to positive (+) battery
terminal.
• REM - Connect to the Remote cable from the
signal source to control amplifier switching.
Applied voltage must be between 7 and
15VDC.
• GND - Connect to good ground, such as the
car frame or grounded metal body. Keep
ground cable length as short as possible.
B FUSE Amplifier protection fuse. Replace with the same
type and capacity.
C SPEAKER/
BRIDGED Connect the speakers to these terminals.
A
B C