Insignia NS-LTDVD19 - 19" LCD TV, User Manual

Page: 9 / 68

7
Insignia NS-LTDVD19 19" LCD TV/DVD Combo
www.insignia-products.com
Connecting a computer
To connect a computer:
1 Make sure that your LCD TV/DVD combo
and computer are turned off.
2 Connect a VGA cable to the VGA port on the
back of the computer and to the
VGA IN jack
on the back of your LCD TV/DVD combo.
Make sure that you tighten the screws on the
ends of the VGA cable.
3 Connect a computer audio cable to the left
and right audio output jacks on the computer
and to the
PC AUDIO IN jack on the back of
your LCD TV/DVD combo.
4 Turn on the computer and your LCD TV/DVD
combo, then press
INPUT to select VGA .
Using basic controls
Turning your LCD TV/DVD combo on and
off
To turn your LCD TV/DVD combo on and off:
1 Plug the power cord into a power outlet. The
LED on the front of your LCD TV/DVD combo
lights yellow.
2 Press POWER . The LED lights green.
Adjusting the volume
To adjust the volume:
• Press VOL+ or VOL– to increase or
decrease the volume. A number appears
on the screen to indicate the volume level.
• Press MUTE to mute the sound. Press
MUTE again to restore the sound.
Selecting the video mode
To select the video mode:
• Press INPUT one or more times to select the
video mode you want. You can select TV ,
Composite , S-Video , VGA , Component ,
HDMI , or DVD .
Using the TV
Selecting the TV signal source
To select the TV signal source:
1 Press MENU , then press CH+ or CH– one or
more times until the following menu opens.
2 Press VOL+ or ENTER , then press CH+ or
CH– one or more times to select Tuning
Band .
3 Press VOL+ or ENTER , then press VOL+ or
VOL– to select the TV signal source. You
can select Cable Auto , Air , Cable , Cable
HRC , or Cable IRC . If you use satellite TV,
select Air or Cable depending on the type of
satellite TV signal.
Memorizing channels
To select channels with the CH buttons, your
LCD TV/DVD combo needs to memorize
channels. When your LCD TV/DVD combo
memorizes channels, it scans for channels with
signals, then stores the channel information into
memory.
To memorize channels:
1 Press MENU , then press CH+ or CH– one or
more times until the following menu opens.
2 Press VOL+ or ENTER , then press CH+ or
CH– one or more times to select Auto Ch
Search .
Notes
If the picture quality is not good:
•
Adjust the brightness and contrast.
• Change the PC’s video resolution.
• Change the refresh rate for the PC’s video
card. If you cannot change the refresh rate for
the video card, you may need to replace the
video card.