www.insigniaproducts.com
12
66" Metal & Glass TV Stand
Anti-tip safety strap installation instructions
You’ll need
1
Position a mounting tab (
WD
) on the back of your TV stand so that the tab is on the bottom, then attach the mounting
tab with a 4.5 × 10 × 8 mm machine screw (
WA
). Repeat this step to attach a mounting tab to the other side on your TV
stand's back.
2
Use a drill with a 5/16" (8 mm) drill bit to drill two holes in your wall approximately two inches below the position of the
mounting tabs on your stand, then insert the plastic sockets (
WC
) into the holes.
3
Insert two 4 × 25 × 8 mm wood screws (
WB
) through the holes in two of the mounting tabs (
WD
) and into the plastic
sockets (
WC
).
4
Make sure that the tabs are on the top, then tighten the screws.
5
Thread a plastic mounting strap (
WE
) through the tabs on your stand and on the wall, then thread the strap through
the strap hole. Repeat this step on the other side of your stand.
6
Pull the straps to tighten them, then thread the straps back through the strap holes to lock them in place.
Note:
We recommend that you install the anti-tip strap as a safety precaution.
Note:
You can use a hammer or rubber mallet to lightly tap the sockets.
WA
4.5 × 10 × 8 mm
machine screw (2)
WB
4 × 25 × 8 mm
wood screw (2)
WC
Plastic socket
(2)
WD
Mounting
tab (4)
WE
Plastic mounting
strap (2)
WD
WD
WA
WB
WC
WE