9
20-, 35-, or 50-Pint Dehumidifier
www.insigniaproducts.com
• Remove the power cord storage bracket from your dehumidifier’s water tank
(on the front), then insert the power cord storage bracket into the back of your
dehumidifier. The power cord storage bracket will click into place.
Using your dehumidifier
1
Plug your dehumidifier’s power plug into a power outlet.
2
Press the
POWER
button, then set your dehumidifier to the desired humidity
level.
Setting the humidity level
1
For drier air, press the
button to set a lower humidity level.
2
For damper air, press the button to set a higher humidity level.
Auto Start and Auto Stop timers
Your dehumidifier has the option to set a timer to turn it on and/or to turn it off.
When you set the Auto Start or Auto Stop timers, the On or Off LED indicators light
to remind you which timer has been set. When both the Auto Start and Auto Stop
times are set in the same sequence, both the On and Off indicator lights remain lit.
Notes:
• When the set humidity level is reached, the dehumidifier turns off automatically.
• When the dehumidifier is turned off, it cannot be restarted again for three minutes.
• When frost builds up on the evaporator coils, the compressor cycles off and the fan
continues to run until the frost is eliminated.
• If the dehumidifier is turned off due to a power outage, it automatically restarts when
the power is restored.
Note:
The humidity level can be set to from 35–85% relative humidity, in increments of
5%.
Notes:
• The timer settings are for one-time only and will need to be set each time you want
your dehumidifier to turn on and off by itself.
• You do not have to use the Auto Start and Auto Stop timers together. You can set one or
the other.
• Turning your dehumidifier on or off at any time or adjusting the timer setting to 0.0 will
cancel the timer function.
• If the LED display shows P2, the timer function is canceled. The P2 error code displays
when the water tank is full or is not in the right position.
Power cord
storage bracket
