Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
(i)the device for operation in the band 5150-5250MHZ is only for indoor use to reduce the potential
for harmful interference to co-channel mobile satellite systems;
(i) l'appareil pour fonctionner dans la bande 5150-5250MHZ est uniquement pour un usage
intérieur afin de réduire les risques d'interférence nuisible aux systèmes mobiles par satellite co-
canal;
(ii)the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with
the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate;
(ii) le gain d'antenne maximal autorisé pour les dispositifs fonctionnant dans la bande 5725-5825
MHz doivent respecter le pire limites spécifiées pour le point-à-point et l'exploitation non point à
point, le cas échéant;
(iii)User should also be advised that hight-power radars are allocated as primary users(i.e. priority
users) of the bands 5250-5350 MHz and that these radars could cause interference and/or to LE-
LAN device;
(iii) L'utilisateur doit également être informé que les radars hight-puissance sont désignés comme
utilisateurs principaux (à savoir les utilisateurs prioritaires) des bandes 5250-5350 MHz et que ces
radars pourraient cause des interférences et / ou à l'appareil LE-LAN;
RSS-102 Statement
This equipment complies with Industry Canada radiation exposure limits set forth for an
uncontrolled environment.
Cet équipement est conforme à l'exposition aux rayonnements Industry Canada limites établies
pour un environnement non contrôlé.
Specific Absorption Rate (SAR) Certification Information
Your wireless mobile device is a radio transmitter and receiver. It is designed and manufactured
not to exceed the exposure limits for Radio Frequency (RF) energy set by the Federal
Communications Commission (FCC) of the U. S. Government.
These FCC RF exposure limits are derived from the recommendations of two expert
organizations: The National Council on Radiation Protection and Measurement (NCRP) and the
Institute of Electrical and Electronics Engineers (IEEE). In both cases, the recommendations were
developed by scientific and engineering experts drawn from industry, government, and academia
after extensive reviews of the scientific literature related to the biological effects of RF energy.
The RF exposure limit set by the FCC for wireless mobile devices employs a unit of measurement
known as the Specific Absorption Rate (SAR). The SAR is a measure of the rate of absorption of
RF energy by the human body expressed in units of watts per kilogram (W/kg). The FCC requires
wireless devices to comply with a safety limit of 1.6 watts per kilogram (1.6 W/kg).
The FCC SAR limit incorporates a substantial margin of safety to give additional protection to the
public and to account for any variations in measurements.
SAR tests are conducted using standard operating positions accepted by the FCC with the mobile
device transmitting at its highest certified power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level, the actual SAR level of the mobile device
while operating can be well below the maximum reported value. This is because the mobile device
is designed to operate at multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station antenna, the lower the power
output of the mobile device.
57
Insignia NS-15AT10 10.1" Wi-Fi Android™ Tablet
