1.Safety
5
The pump has moving parts. Never place your fingers inside the pump during operation.
NEVER operate with the suction and discharge valves closed.
NEVER spray the electrical motor directly with water. The standard protection of the motor is IP-55:
Protection against dust and water spray.
1.4.3.
During maintenance
in Chapter 8 shall always be observed.
NEVER disassemble the pump until the pipes have been emptied. Remember that liquid will remain
inside the pump’s
body (if does not have a purge). Bear in mind that the pumped liquid may be
hazardous or extremely hot. Consult the regulations in effect in each country for these cases.
Do not leave loose parts on the floor.
ALWAYS disconnect the electrical power to the pump prior to carrying out any maintenance. Remove
the fuses and disconnect the cables from the motor’s terminals.
All the electric work should be carried out by authorised personnel.
1.4.4.
Compliance with the instructions
The non-compliance with any of the instructions may impose a hazard for operators, the atmospheric conditions of the room
and for the machine; also, it may cause the loss of any right of claiming damages.
These non-compliances may result in the following hazards:
•
Important failures of the machine's/plant's operation.
•
Non-compliance with specific maintenance and repair procedures.
•
Possibility of creating electric, mechanical and chemical hazards.
•
The atmospheric conditions in the room may impose a hazard due to the substances that are released.
1.4.5.
Warranty
We wish to emphasize that any warranty provided will be void and that we have the right to receive compensation in the case
of any civil responsibility claim by products presented by third parties in the following cases:
•
The operation and maintenance work has not been carried out in accordance with the corresponding service
instructions; the repairs have not been carried out by our personnel or they have been carried out without our
written authorization;
•
Modifications have been carried out of our products without our prior written authorization;
•
The parts or lubricating agents used are not original INOXPA parts/lubricants;
•
The material has been improperly used due to errors or negligence or it has not been used according to the
indications and for the desired purpose.
•
The pump parts have been damaged by high pressure due to not having used a safety or relief valve.
The supplied General Conditions of Delivery also apply.
No modification of the machine is permitted without prior authorization from the manufacturer. For
your safety, use only original spare parts and accessories. The usage of other parts will relieve the
manufacturer of any liability.
Any change in the operating conditions shall be conducted only with the previous written
authorization of INOXPA.
Please contact us in case of any doubt or if you require a more detailed explanation regarding particular data
(adjustment, assembly, disassembly, etc.).