Installation
8
INOXPA S.A.U.
· 01.030.30.05EN · (0) 2021/01
5.3. TRANSPORT AND STORAGE
The PROLAC HCP pumps are often too heavy to be stored manually.
Use an appropriate means of transport.
Use the points which are indicated in the drawing for lifting the pump.
Only authorized personnel should transport the pump.
Do not work or walk under the heavy loads.
Lift the pump as indicated below:
•
always use two support points placed as far apart as possible.
Always remove the motor shroud before hoisting
•
secure the supports so that they will not move.
to consult dimensions and weights.
During the transport, disassembly or assembly of the pump, there is a risk of loss of stability and that
the pump could fall down and cause damages to the operators. Make sure that the pump is properly
supported.
5.4. LOCATION
Place the pump in a position that allows enough space around it to provide access to the pump as well as to the
motor. See chapter
to consult the dimensions and the weights of the pumps.
Place the pump on a flat and level surface.
Install the pump so as to allow proper ventilation.
If the pump is installed outdoors, it should be covered by a roof. Its location should allow easy access
for inspection or maintenance operations.
ATTENTION
ATTENTION
ATTENTION
0
1
.0
3
0
.3
2
.0
0
0
7
ATTENTION
