1/24/14 06574A © Inovonics, 2014 - www.inovonics.com
2
End User Recommendations
IP54 certification is classified as water-resistant, but not waterproof. The
products are not designed for submersion in water. As such, we offer the
following recommendations for end users:
3.3 Battery Replacement
The transmit LED on the EN1223D-15 pendant transmitter will flash every
10 seconds as long as the battery is operational. If the transmit LED
ceases to flash, the battery is in need of replacement.
Replacement batteries can be purchased from Inovonics using the
following part numbers
• BAT609 for a single battery
• BAT609-25 for a 25-count bulk pack
To replace the batteries:
1.
Remove the three housing screws on the back of the transmitter.
2.
Remove the rear cover to expose the side of the board which holds the
battery.
Caution:
Carefully separate the rear housing cover, ensuring the reset
button plunger assembly does not fall out of the housing (Figure 2).
3.
Remove the depleted battery.
4.
Slide the new battery under the battery holder, ensuring that it is fully
inserted and that the positive terminal (+) faces up (Figure 2).
5.
Replace the rear housing cover.
6.
Replace the three housing screws, tightening them to 1.25 inch-pounds
torque.
7.
Once the unit has been sealed, press the reset button located on the
rear housing to complete the configuration (Figure 1).
Note:
If you do not have a torque driver, tighten to a snug fit, being careful
not to strip the housing.
Note:
Tighten the housing screws evenly to help ensure a good seal and
maintain water-resistance.
Caution:
Over-tightening the housing screws can result in microcracks in
the plastic, gaps in the gasket material, and/or stripping of the bushing. Any
of these conditions can compromise the water-resistance of the device.
4 Test the Transmitter
The transmitter should be tested weekly and after registration to ensure
operation.
To test the transmitter:
1.
Press both activation buttons simultaneously for at least one second
and ensure the transmit LED lights and the alarm is received by the
receiver or gateway.
2.
Press the reset button and ensure the transmit LED lights.
5 US Patent Numbers
• 7,154,866
• 7,554,932
• 7,746,804
6 Specifications
Dimensions: 5.6 x 4.8 x 1.8 cm (2.2 x 1.9 0.72”)
Operating temperature: 0 to 60°C (32 to 140°F)
Operating environment: Water-resistant, non-submersible
Certifications: IP54 Dust and Water Resistance (IEC 60529)
Typical battery life: 1-2 years
Battery type: Renata CR2450, Panasonic CR2450
Power requirement: 3 VDC, 60 mA
Note:
Specifications and data are subject to change without notice.
7 Television and Radio Interference
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
8 FCC Part 15 and Industry Canada Compliance
This device complies with part 15 of the FCC Rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
9 Warranty and Disclaimer
Note:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Inovonics Wireless Corporation ("Inovonics") warrants its products
("Product" or "Products") to conform to its own specifications and to be free
of defects in materials and workmanship under normal use for a period of
thirty-six (36) months from the date of manufacture. Within the warranty
period, Inovonics will repair or replace, at its option, all or any part of the
warranted Product. Inovonics will not be responsible for dismantling and/or
reinstallation charges. To exercise the warranty, the User ("User", "Installer"
or "Consumer") must work directly through their authorized distributor who
will be given a Return Material Authorization ("RMA") number by Inovonics.
Details of shipment will be arranged directly through the authorized
distributor.
This warranty is void in cases of improper installation, misuse, failure to
follow installation and operating instructions, alteration, accident or
tampering, and repair by anyone other than Inovonics.
This warranty is exclusive and expressly in lieu of all other warranties,
obligations or liabilities, whether written, oral, express, or implied. There is
no warranty by Inovonics that Inovonics product will be merchantable or fit
for any particular purpose, nor is there any other warranty, expressed or
implied, except as such is expressly set forth herein. In no event shall
Inovonics be liable for an incidental, consequential, indirect, special, or
exemplary damages, including but not limited to loss of profit, revenue, or
contract, loss of use, cost of down time, or interruption of business, nor any
claim made by distributor's customers or any other person or entity.
This warranty will not be modified or extended. Inovonics does not
authorize any person to act on its behalf to modify or extend this warranty.
This warranty will apply only to Inovonics Products. Inovonics will not be
liable for any direct, incidental, or consequential damage or loss
whatsoever, caused by the malfunction of Product due to products,
accessories, or attachments of other manufacturers, including batteries,
used in conjunction with Inovonics Products.
Usage Situation
OK to Use?
Cautions
Shower
Yes
Do not spray water directly on
the device at distances of less
than 12 inches; avoid spraying
water at high pressure
Bath
Yes
Do not submerge the device
Rain
Yes
Avoid extended exposure;
wear the device under a
sleeve, shirt, or jacket
Water Exercise
No
Do not use the device during
these activities
