Inovonics 510, Operating And Maintenance Instruction Manual

Page: 24 / 27

— — 20
NAVIGAT ING T HE PART S LIS T INGS
This section contains listings of component parts used in the
Inovonics 510. Not all components are listed by schematic reference
designation; those that are considered ‘generic’ are qualified,
however.
Descriptions may or may not specify a particular manufacturer.
When no manufacturer is called out, the term (open) advises that
any manufacturer’s product carrying the given part number (or the
same description in the case of a generic part) is acceptable.
If a part is not listed at all, this means that we do not consider it a
typical replacement item. Should you need to order an unlisted
part, call, write, fax or e-mail the factory with a brief description of
what it is that you need. We’ll then do our very best to figure out
what to send you.
Components with reference designations below 500 are contained on
the main printed circuit board. Designations in the 500s are
associated with the front panel subassembly, and those in the 600s
are chassis-mounted components.
COMPONENT PART S LIS T INGS
Unless specifically noted by component reference designation,
capacitors are specified as follows:
a: Under 100pF are general-purpose disc ceramic capacitors with
no specific technical specification. The letter ‘p’ following the
value indicates picofarads.
b: 100pF to 0.47µF are of the metalized Mylar or polyester
variety. Whole number (XXp) values are picofarads, decimal
values are microfarads. All capacitors in this category have 5%
tolerance and are rated at 50VDC or better. The style used in
the Model 510 is the “minibox” package with lead spacing of 0.2
inch. The preferred manufacturer is WIMA, their FKS-2 or
MKS-2 series. Possible alternates are the CSF-Thompson IRD
series or the Vishay-Roederstein KE-1808 or KT-1817 series.
c: 1.0µF and above are general-purpose aluminum electrolytics
with radial leads. A safe voltage rating for any electrolytic in the
Model 510 would be 25V, but because of size and other reasons a
replacement capacitor should always carry the same rating as
the one being replaced.
C1,2 Capacitor, Y-class Ceramic Disc, .0047µF, 440VAC;
Murata/Erie DE7150 F 472M VA1-KC
C3 Capacitor, Axial Electrolytic, 1000µF, 35V; (open)
C11,12 Capacitor, DM-15 Mica, 33pF; (open)
CR1,2,4 Diode, Silicon Rectifier; (open) 1N4005