Inoksan INO-SBS140/S, Instruction Manual

Page: 17 / 24

17

Check the availability of the power supply in the
socket.

Check whether the thermostat switch is on or off.

Check whether the condenser’s chilling fan runs
or not.

If all units and functions operate properly but
the condenser is still out of work, contact with
the authorized technical service.
The condenser gives out unusual noise:

Check the cleanliness of the condenser. Remove
and dust and dirt.

Effect the periodical maintenance of the fan
motor.
If the failure still prevails, contact with the
authorized technical service
6.
POSSIBLE ERRORS AND REMEDIES
ERROR POSSIBLE CASUSES POSSIBLE REMEDIES
Equipment is not
powered .
It is not plugged . Plug in/ call the authorized service.
Power inlet cable is out of order/ cut Check / call the authorized service..
Main switch of the equipment is
turned off.
Turn on the mains switch / call the
authorized service.
Control board is not energized. Check / call the authorized service..
On/off button is turned off. Turn on the on/off button .
Equipment does not
cool enough .
Cooling temperature is not selected
correctly. Check the cooling temperature and, if
necessary, increase the temperature.
Equipment is positioned near a heat
source (cooker, oven etc.) or being
exposed to directly .
As defined in “INSTALLATION” chapter,
keep away the equipment from the source
of heat and direct sunlight. .
Ventilation holes are obstructed. Open the ventilation holes.
Condenser is dirty. Check / clean.
In the cooling cycle, there is a
discjucture/cut at any point or the
cooling gas finished. Call the authorized service..
Evaporator has excess frost deposit. Perform a defrost cycle.
Ambient temperature is too high.
Check the ambient temperature and, if
possible, reduce.
Equipment cools too
much . Cooling temperature is not selected
correctly. Check the cooling temperature and, if
necessary, decrease the temperature.
Equipment does not
illuminate .
It is not plugged. Plug in. / call the authorized service.
Power cable is out of order/ cut . Check / call the authorized service..
Mains switch is turned off. Turn on the mains switch.
Control board is not energized. Check / call the authorized service..
Illumination button is turned off. . Turn on the illumination button .
Flourescant lamp is out of order. Check / call the authorized service..
Refrigerator motor does
not operate. Socket is not energized. Check.
Cooling control device is turned
off. Check / turn on.
Condenser fan does not work. Call the authorized service..
Other Call the authorized service.
Refrigerator motor
operates noisy.
Condenser is dirty. Check / clean.
Fan motor is out of order . Call the authorized service..
Other Call the authorized service.
Equipment does not
defrost .
Defrost adjustment is not done on
the cooling control device. Check. Adjust defrost.
Cooling control device is out of
order. Call the authorized service..
Other Call the authorized service..