8
FIG-21
install the wooden cover
FIG-22
install the warm barothermohygrogram
19
．
Take out the sauna heat stove, and examine the equipment.
See FIG-23.
Then disassemble one side batten of the wooden
support frame.
See FIG-24.
20
．
After that, upend the sauna stove into the wooden frame, and disassemble the right aluminum board, then connect the power
supply line of the sauna stove.
（
Note: red wire is connected with L, green wire is connected with N, the double is ground
line which is connected to the join with mark ) and lock them tight with screws.
See FIG-25.
FIG-23
examine the stove
FIG-24
disassemble the wooden frame
FIG-25
connect the power supply line of stove
FIG-26
location of the stove
21. After assembling the wires, install the right aluminum board and wooden batten, and place the stove on the right location.
See FIG-26
22
．
Finish the installation.
23. Put some stones on the sauna stove, about 10-15kgs.
Attention: The temperature inside stove is very high, we must use high quality sauna stones. Because the bad quality stone can
’
t
afford high temperature, easily be cracked; And it will damage the heating tube when become hot and irrigated by water.
