BUTTON PROGRAMMING
With work surface at its lowest position,
press up button and release.
Press up or down button
to stop the
work surface at desired height.
Wait several seconds for light to blink.
While light is blinking,
press up and
down buttons at the same time and release.
1
2
3
1
HOW TO PROGRAM
HOW TO ERASE
With work surface at its lowest position,
press and hold down button
for three seconds.
Light will blink
to confirm setting has been erased.
3
s
STEP 6
Your Winston-E height adjust
setting has been erased!
To reprogram the single-touch height
adjust setting, follow the steps
“How to Program” above.
Your Winston-E
is now programmed!
Next time the up button is pressed,
the work surface will rise and
automatically stop
at your preset height.
To reprogram your single-touch
height adjust setting,
you will first need to erase
the programmed setting
(see below).
Summary of Contents for Winston-E Workstation Triple WNSTE-3
