NV10 Operations Manual 26
•
Remove the 4 nuts, 2 metal clamps, star washers and 2 bolts from each side of the
bezel as above (see figure 10).
•
Place PA231 through the aperture in the door of the machine from the front.
•
Fit the two metal clamps and star washers and tighten the nuts onto the bolts
(recommended torque 25cN per metre).
•
Fit the main bezel assembly onto the bolts with the black part to the top. Fit the star
washers and tighten the nuts onto the bolts (recommended torque 25cN per metre).
8.3 CASH BOX INTERFACE
It is important that there is sufficient space for the ‘’initial exit’’ and ‘’final exit’’ of notes
from the NV10 note path, before entry into the cash box/chute without any obstructions
(see Appendix C).
For help on installing the NV10 into a new design please contact support@innovative-
technology.co.uk.
9 ROUTINE MAINTENANCE
The NV10 Validator has been designed to minimise any performance variation over time.
Much of this is achieved by careful hardware and software design. However, depending
upon the environment the NV10 may at some time require cleaning, belt changing or note
path clearing.
9.1 CLEANING
CAUTION: DO NOT USE SOLVENT BASED CLEANERS SUCH AS ALCOHOL, PETROL,
METHYLATED SPIRITS, WHITE SPIRIT or PCB CLEANER. THIS WILL RESULT IN PERMANENT
DAMAGE TO THE VALIDATOR, ONLY USE A MILD DETERGENT.
Remove the NV10 from its bezel. Push the 2 red Note Path Access Buttons on the sides of
the NV10 downwards and then inwards towards the body of the NV10 (see figure 9) and
lift to expose the note paths, place them on a clean dry surface. The note path will now be
exposed for cleaning, (see figure 11).
Carefully wipe the surfaces with a soft lint free cloth that has been dampened with a water
and mild detergent solution (i.e. household washing up liquid). Take particular care around
all the sensor lenses (see figure 11), ensuring they are clean and dry. Clean any metal
debris that may be attached to the magnetic sensor.
If a lens has become badly scratched do not attempt to polish it. Contact ITL for further
advise, as there may be damage to the optical properties of the lens.
CAUTION: WHEN CLEANING THE ‘’RECESSED’’ FRONT SENSOR, USE A SMALL SOFT BRUSH
OR COTTON WOOL BUD.
Copyright Innovative Technology Ltd 2008 GA333-5
