4400 AND 4800 SERIES MIXERS
MAY 1999
SECTION
4
GROUP
20
SUB
B
PAGE
25
INSTALLATION INSTRUCTIONS
MODELS 4400 SERIES AND 4800 SERIES AUTOMATIC MIXERS
Figure 25 - Direct Output source selection
Jumper setup
DIRECT OUTPUT SOURCE SELECTION
The Direct Output mix can be sourced from
one of three points for each gated input. The
three points are Pre Input Option, Post Input
Option, and Post Gate. The selection is made
by the placement of jumpers. Refer to the fig-
ure below for the details of jumper setup.
When shipped from the factory, there is a
jumper in the Post Gate position for each in-
put.
The Pre Option selection feeds the input sig-
nal prior to input processing to the Direct Out-
put. Input processing refers to the selected
input option.
The Post Option selection feeds the input sig-
nal to the Direct Output after it has received in-
put processing, but before it is gated.
The Post Gate selection feeds the input signal
to the Direct Output after it has received input
processing and after it pases through the
gating switch. This is the same signal which is
fed to the Main Output mix bus.
Never install jumpers in more than one posi-
tion for the pre-option, post option, or post
gate setup.
