MTX-L_Manual.doc
10
before programming the MTX-L. So there might be some small ‘rounding errors’ when
you open LM Programmer and review your settings in the future.
Click the ‘Program’ button to download the new data into the MTX-L. Once the unit is
programmed the ‘Program’ button will grey out.
The analog output can be programmed from 0 to 5 volts and from 1.5 to 8.191 lambda.
Factory Programmed Defaults:
Analog Output 1 is programmed to output between 0 V for an AFR of 7.35 (gasoline)
and 5.0V for an AFR of 22.39. Analog Output 2 simulates a typical narrow band oxygen
sensor. The configuration is 1.1 V for an AFR of 14 and .1 V for an AFR of 15.
Other curves, of course, are easily programmable.
3.2.2
Advanced output programming
The ‘Advanced’ button allows programming to set the analog out update speed and the
voltage output during sensor Warm-up and Error Condition. The factory defaults of the
analog outputs is to update the outputs 1/12 of a second. The factory default voltage
output is set for 0 volts for both the Warm-up and Error Condition.
When setting the MTX-L to the slower response speed settings the measured mixture
data will be averaged over the response time setting before being output.
