MODE BUTTON
Use the “
MODE
” button to select one of the available modes. The
selected mode will be displayed on the remote controller and the
appropriate light will illuminate on the front display panel.
AUTO
– Unit will automatically select heating or cooling to maintain
room temperature between 68°F and 77°F. The remote controller
will display the Auto Mode icon with no setpoint. The front panel
display will show "77."
COOL
– To cool to selected setpoint and remove moisture.
System varies compressor speed to maintain desired temperature.
HEAT
– To heat to selected room setpoint. System varies compressor
speed to maintain desired room temperature.
FAN ONLY
– To circulate air without heating or cooling. Use Fan Speed button to select
speed from low to high.
DRY
– Select
DRY MODE
to increase moisture removal during warm humid conditions.
1. If the Room Temperature is more than 4°F above the set temperature, the system will
be operating in cooling mode with low fan speed.
2. If the Room Temperature is between 4°F higher than and 4°F less than the set
temperature, the system will cycle 6 minutes
ON
and 4 minutes
OFF
in cooling mode.
The indoor fan will be at low speed.
3. If the Room Temperature is more than 4°F below the set temperature, the system will
be
OFF
and the indoor fan will be at low speed.
: AUTO
: COOL
: DRY
: FAN ONLY
: HEAT
Icons Displayed
OPERATION OF WIRELESS REMOTE CONTROLLER
TIMER SETTING
TIMER ON button
To set when you want the unit to turn On at the end of a selected
time period, use the button labeled “TIMER ON on the remote
controller. Press this button to make the clock icon disappear,
replaced with the word “ON” (blinking). Press“+” or“–” buttons
to adjust timer setting 1 minute
at a time. Press and hold “+”
or “–” button to set timer more quickly. Press“TIMER ON” button
again to confirm setting, and the word “ON” will stop blinking.
To cancel, press“TIMER ON” button again.
Timer ON Display
9
OWNER’S MANUAL
Innovair Elite Mini Split
