
13
S
I
U
2.8
A
B
1
2
3
4
5
6
A
B
1
1
2
6
5
3
4
EN
INSTALLATION
The unit can be installed either in the lower part (near the
floor) or in the upper part (near the ceiling) of the wall. In
order to optimise air distribution and comfort, the direction
of the air flow can be modified by adjusting the position of
the air flap.
The appliance is supplied ready to be installed in the lower
part of the wall, so air is dispensed upwards. The same
configuration can also be used in the upper part of the wall
in cooling mode, which increases the air flow in the room
(coanda effect).
This operation must be performed while the appliance
is switched off and disconnected.
-
Open the air outlet flap gently
-
Remove the flap opening block insert located internally
on the right of the air outlet mouth and place it in the
lower hole.
-
Remove the upper grill
-
Remove the two plastic side panels by moving them
up
-
Unscrew the fixing screws
-
Remove the front panel
- Place the bottom cover and fix it with the supplied
screws
-
Refit in the reverse order.
After adjusting the air outlet flap position, it is necessary to
set up the electronic control of the appliance:
- Keep pressed the
button on the display for 5
seconds;
- The
dn
(lower wall) symbol lights up on the display
-
Press the
button again;
- The
uP
(upper wall) symbol lights up on the display.
-
If no other operations are performed in the following 2
seconds, the new setting is memorised.
For the appliance to work properly, each time the
configuration of the air outlet flap is modified, the
electronic control must be set.
Modifications from lower wall to the upper wall position
High/low installation configuration
High installation
Low installation (factory settings)
Block insert
Bottom cover
Fixing screws
Upper grill
Plastic side panels
Front panel